To simplify the mod, I used my plasma cutter to cut out the two right hand rods, I will leave the left one in place and reuse it.

Here is the test fit for the C channel that will be added to extend the factory tire carrier.  The two rods that I cut out will be welded to this.  Note how it is notched for the zirk fitting on the pivot.

Another shot of the extension before final weld.

Here is the extension welded on and the rods in place.

I welded in a vertical tube to brace the carrier and to provide a place to mount the gas can rack.  You can see the mounts for the hi-lift mounted on the stock carrier at the top and bottom.

Here is everything mounted.  The tail lights are still visible and everything clears the body when it's opened.

Here is how the gas can is mounted to the vertical bar.  I used some 1 1/2" box steel braced, and added some tabs so that the mount can be removed.

I had a long debate with myself as to how to mount the can.  Mounting at an angle seemed to be the best option to properly clear the body and to not stick out too far.